Installing R1 And R4 Paddle Cards - Dell PowerEdge R760 Installation And Service Manual

Figure 207. Removing the R4 paddle card
Next steps
1. Replace the paddle cards.

Installing R1 and R4 paddle cards

R1 and R4 paddle cards are supported on 24 x 2.5-inch NVMe Gen4 (passive) configuration only.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud
4. Remove the cooling fan cage
NOTE: Observe the cable routing before disconnecting the cables.
5. Remove the paddle card cable from side wall bracket.
6. Disconnect the paddle card cables from the drive backplane.
Steps
1. Holding the edges, align the hole on the paddle cards with the guides on the system board.
2. Lower the paddle cards into place and press until the paddle card connector is fully seated on the system board connector.
264 Installing and removing system components
Safety instructions.
Before working inside your
or remove the GPU air shroud.
assembly.
system.