Optional Front Bezel; Removing The Front Bezel - Dell PowerEdge R760 Installation And Service Manual

● 5 mm hex nut screwdriver
● Plastic scribe
● 1/4-inch flat blade screwdriver
● Wrist grounding strap connected to the ground
● ESD mat
● Needle-nose pliers
You need the following tools to assemble the cables for a DC power supply unit:
● AMP 90871-1 hand-crimping tool or equivalent
● Tyco Electronics 58433-3 or equivalent
● Wire-stripper pliers to remove insulation from size 10 AWG solid or stranded, insulated copper wire
NOTE: Use alpha wire part number 3080 or equivalent (65/30 stranding).
NOTE: For information about DC PSU cabling instructions, go to
Servers > PowerEdge R760 > Select This Product > Documentation > Manuals and Documents > Cabling instructions
for – 48 – 60 V DC power supply.

Optional front bezel

NOTE: LCD panel is optional on the front bezel. If the front bezel has an LCD panel, see

Removing the front bezel

The procedure to remove the front bezel with and without the LCD panel is the same.
Prerequisites
1. Follow the safety guidelines listed in the
2. Keep the bezel key handy.
NOTE: The bezel key is part of the LCD bezel package.
Steps
1. Unlock the bezel.
2. Press the release button, and disengage the left end of the bezel.
3. Unhook the right end, and remove the bezel.
80 Installing and removing system components
Safety instructions.
https://www.dell.com/poweredgemanuals
LCD panel
> Rack
section.