Table of Contents
Advertisement
Figure 71. Installing an expansion card into a Riser 2c
Next steps
1. If applicable, connect the cables to the expansion card.
2.
Install the air
shroud.
3. Follow the procedure listed in
4. Install any device drivers required for the card as described in the documentation for the card.
NOTE:
While replacing faulty storage controller, FC, or NIC card with the same type of card, after you power on the
system; the new card automatically updates to the same firmware and configuration of the faulty one. For more information
about the Part replacement configuration, see the Lifecycle Controller User's Guide at https://www.dell.com/idracmanuals.
Optional serial COM port
This is a service technician replaceable part only.
Removing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air
shroud.
Steps
1.
Lift the expansion card riser
board.
2. Open the latch, slide the serial COM port out of the expansion card riser, and the lock the latch .
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
After working inside your
Safety
instructions.
Before working inside your
(Riser 1, Riser 2c) and disconnect the serial COM port cable from the connector on the system
system.
system.
Installing and removing system components
73
Advertisement
Table of Contents
