Figure 148. Installing the intrusion switch module
Next steps
1.
Install the 2U air
shroud.
2. Follow the procedure listed in
Optional serial COM port
This is a service technician replaceable part only.
Removing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the 2U air
shroud.
4. Remove the
Riser
3.
NOTE:
The serial COM port is supported only on slot 5 of the expansion card riser 3 .
NOTE:
The procedure to remove the serial COM port is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Open the latch on the expansion card riser and slide the serial COM port out of the expansion card riser.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
173