Figure 122. Installing the PEM power board
Next steps
1. Install the PEM.
2. Install the
Cooling fan cage
3. Install the
Air
shroud.
4. Follow the procedure listed in
Optional serial COM port
This is a service technician replaceable part only.
Removing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. If required, remove PCIe card from slot 2.
NOTE:
The serial COM port is supported only in slot 1 of the expansion card riser.
Steps
1. Disconnect the serial COM port cable from the rear I/O board.
assembly.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
157