Install The Access Point On A Pole Using Kt-147407-02 Bracket Parts - Extreme Networks ExtremeWireless AP560h Installation Manual

Install the Access Point on a Pole Using KT-147407-02
Bracket Parts
5. Tighten the cable clamp screw clockwise, tightening the band around the pole.
Figure 9: Tightening the cable clamps on the POLE01 bracket

Install the Access Point on a Pole Using KT-147407-02 Bracket Parts

Before You Begin
The following hardware is required for pole installation using KT-147407-02 bracket
parts:
•
Flat part of the KT-147407-02 bracket
•
1-axis tilt part of the KT-147407-02 bracket
•
Pole part of the KT-147407-02 bracket
•
Four M6 screws
•
Two hex-head M12 stainless-steel screws
•
Two hex-head M12 stainless-steel nuts
•
Two 0.5 in. wide stainless-steel cable clamps
•
One access point
30 ExtremeWireless™ AP560h Access Point
Install the Access Point