Install The Access Point On A Pole Using Kt-147407-02 Bracket Parts And Kt-150173-01 Extension Arm - Extreme Networks AP5050U Installation Manual

Extreme wireless 802.11ax wi-fi 6e outdoor access point
Table of Contents

Advertisement

Install the Access Point
Install the Access Point on a Pole Using KT-147407-02 Bracket Parts and
KT-150173-01 Extension Arm
Before You Begin
The following hardware is required for pole installation using KT-147407-02 bracket parts and
KT-150173-01 extension arm:
Flat part of the KT-147407-02 bracket
1-axis tilt part of the KT-147407-02 bracket
Pole part of the KT-147407-02 bracket
KT-150173-01 extension arm
Six M6 screws
Four hex-head M12 stainless-steel screws
Four hex-head M12 stainless-steel nuts
Two 0.5" wide stainless-steel cable clamps
One access point
About This Task
Install the access point on a pole with all three KT-147407-02 bracket parts and KT-150173-01 extension
arm
Procedure
1. Attach the flat part and the 1-axis tilt part of the KT-147407-02 bracket to the access point.
For instructions on how to attach the bracket parts, see
Surface Using the KT-147407-02 Bracket Parts
2. Align the circular holes on one end of the KT-150173-01 extension arm against the large holes on the
1-axis tilt bracket.
3. Attach the KT-150173-01 extension arm to the 1-axis tilt bracket by using two hex-head M12 stainless-
steel screws and two hex-head M12 stainless-steel nuts.
Install the Access Point on a Pole Using KT-147407-02
ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050U Access Point
Bracket Parts and KT-150173-01 Extension Arm
Install the Access Point on a Wall or Flat
on page 27.
37

Advertisement

Table of Contents
loading

Table of Contents