Table of Contents
Advertisement
Install the Access Point on a Flat T-bar Using Main
Mounting Bracket and KT-135628-01 Adapter
4. Place the access point on the bracket feet and slide it down to lock it in place.
Hold the access point and rock it back and forth to ensure that it is securely mounted.
5. Replace the ceiling tiles.
Install the Access Point on a Flat T-bar Using Main Mounting Bracket and
KT-135628-01 Adapter
Before You Begin
Ensure that the T-bar meets the following conditions before installing the main mounting bracket with
the KT-135628-01 adapter on a T-bar:
•
T-bar width can be 15/16 in. (24 mm).
•
T-bar bottom must be flat all the way across.
•
T-bar must be structurally sound.
•
T-bar maximum base thickness must not exceed 0.055 in. (1.400 mm).
•
Ceiling tile may protrude up to 0.35 in. (8.89 mm) below the T-bar.
About This Task
If the ceiling tile is not flat and has a protrusion, use the main mounting bracket with the KT-135628-01
adapter. Attach the adapter to the main mounting bracket before attaching the bracket to a T-bar.
Procedure
1. Attach the T-bar adapter to the main mounting bracket by lining up the small bends on the adapter
with the long raised parts on the main bracket.
2. Pull up the KT-135628-01 adapter locking pin, and twist clockwise.
After the adapter is put on the main mounting bracket, untwist the locking pin, and ensure that the
locking pin goes into the locking pin hole on the main bracket and locks in place.
22
ExtremeWireless™ Access Points AP410i/e
Install the Access Point
Advertisement
Table of Contents
