Fig 4.10 Manual Adjustment Of Speed Command Offset; Fig 4.11 Alarm Reset - OE Max Controls CSDJ Plus User Manual

4 - 14 CSDJ Plus Servo Drive User's Manual
ENTER
(In case of the manual adjustment of torque command offset , " Co-tC" is displayed.)
E. Alarm Reset
Error status can be reset in USr-07 of the jog mode. Resetting method is as follows.
ENTER
Press this key to save
MODE
changed content.
SET
• The set offset of speed command can be checked
in con-10, Unit[mV]
• The set offset of Torque command can be
checked in Con-11, Unit[mV]

Fig 4.10 Manual Adjustment of Speed Command Offset

ENTER

Fig 4.11 Alarm Reset

＊When it is connected to the host controller, the
offset must be adjusted after making the "0V"
output of the host controller
(Be aware that the status of servo stop control
from the Feedback control system is not same as
voltage output of '0V'.)
using variable
＊When
resistor), motor rotation cannot be completely
stopped even if the offset has been adjusted.
Use zero-clamp function.
Use this key to adjust so the motor
stops when Servo is ON.
ENTER
RESET
resistor(or general