Fig 3.1 Example Of Power On And Off - OE Max Controls CSDJ Plus User Manual

3 - 4 CSDJ Plus Servo Drive User's Manual
3.2 Startup
In order to avoid unexpected accidents during startup, operate the servo motor
without the load.
When startup is done with the load, then operate the servo motor after setting
!
the system, so that the operation can be emergency stopped anytime.
Warning
When the load is connected and startup is done with the operator, set the
acceleration and deceleration time properly in SEt-19 and SEt-20.
A. Power ON and OFF
When supplying the power with the power sequence made, the power is supplied to the push
button switch, and the user must push the button for one second. Check the color of LED
and proceed according to the procedure.
Use the push type button, which is
connected only when the button is pushed.
Press the button for about 1 second.
Circuit
Breaker
Power
Also connect the
power ground to
the PE terminal
Plate
• LED Display
Table 3.1 LED Color and Description
Color
Green
Orange
Red/Green
Power Off S/W
1 Relay
1 MC
Noise
Filter
Frame
1 Relay
External
Power 24V

Fig 3.1 Example of Power ON and OFF

Servo Power ON
Servo ON
Alarm (Flickers in green and red every 0.2 seconds.)
Power On S/W
1 MC
1 Relay
Alarm Lamp
L1
L2
SALM
CN1-45
SALM-
CN1-46
Servo Drive Status
Connect when there is a
need to cut off the power
according to the alarm.
1 MC
U
V
M
W
PE