Install The Access Point Using Kt-147407-02 Bracket Parts And Kt-150173-01 Extension Arm - Extreme Networks ExtremeWireless AP560i Installation Manual

Install the Access Point
Install the Access Point Using KT-147407-02 Bracket Parts and KT-150173-01
Extension Arm
Before You Begin
The hardware required for installation:
•
Flat part of the KT-147407-02 bracket
•
1-axis tilt part of the KT-147407-02 bracket
•
KT-150173-01 extension arm
•
One access point
Figure 6: KT-150173-01 extension arm
About This Task
The KT-150173-01 extension arm is used in combination with the wall and pole bracket parts of the
KT-147407-02 bracket.
Procedure
1. Attach the flat part of the KT-147407-02 bracket to the access point using two M6 screws.
2. Place the flat part of the KT-147407-02 bracket inside the 1-axis tilt bracket, and attach the 1-axis tilt
bracket to the flat bracket using four M6 screws.
3. Using the KT-150173-01 extension arm as a template, mark and drill four hole centers on a flat
surface.
The holes must be within the circular cuts in the end of the flange.
Install the Access Point Using KT-147407-02 Bracket
Parts and KT-150173-01 Extension Arm
ExtremeWireless™ AP560i Access Point 25