Table of Contents
Advertisement
SAEx 07.2-UW
Assembly
5.3.
Accessories for assembly
5.3.1.
Handwheel temporarily mounted
5.3.1.1. Handwheel fitting/disassembly
Fit handwheel
Dismount handwheel
18
SAEx 16.2-UW / SAREx 07.2-UW
for setting tasks
Figure 12: Version prepared for temporary handwheel operation (with protective cap)
[A]
Protective cap for operation (and on delivery)
[B]
Handwheel fitted (handwheel must be ordered separately)
In this version, the handwheel is provided for temporary use such as setting tasks
during commissioning or during maintenance. The handwheel must be removed
again for operation. A protective cap made of plastics is provided to protect the input
shaft against deposits.
Figure 13: Fit handwheel
[1]
Spacer
[2]
Input shaft
[3]
Handwheel
[4]
Retaining ring
[5]
Hose clamp
[6]
Protective cap
1.
Loosen hose clamp [5] and remove protective cap [6].
2.
If required, fit spacer [1] on input shaft [2].
3.
Slip handwheel [3] onto input shaft.
4.
Secure handwheel [3] with retaining ring [4].
5.
Remove retaining ring [4] and pull off handwheel [3].
6.
If provided, remove spacer [1].
7.
Slide protective cap [6] onto input shaft and secure with hose clamp [5].
SAREx 16.2-UW Control unit: electronic (MWG)
ACExC 01.2 Non-Intrusive Profibus DP
Advertisement
Table of Contents
