AUMA SAEx 07.2-UW Operation Instructions Manual page 30

SAEx 07.2-UW
Electrical connection
Information
30
SAEx 16.2-UW / SAREx 07.2-UW
Connection with support terminals for line topology
When using solid cables (single or multiple strands), additional support terminals
must be used.The support terminals (terminal blocks) are mounted above the terminal
carrier.
Figure 28: Terminal assignment of support terminals: Channel 1 (1A/1B)
[XK] Terminal assignment according to wiring diagram (customer connection):
□ Terminals 31 and 32 if another fieldbus device follows
Terminals 31 34 if the actuator is the last fieldbus device
■
Figure 29: Terminal assignment of support terminals: Channel 2 (2A/2B)
[XK] Terminal assignment according to wiring diagram (customer connection):
▣ Terminals 35 and 36 if another fieldbus device follows
Terminals 35 38 if the actuator is the last fieldbus device
■
Always link A connections to green wire and B connections to red wire.
SAREx 16.2-UW Control unit: electronic (MWG)
ACExC 01.2 Non-Intrusive Profibus DP