AUMA SAEx 07.2-UW Operation Instructions Manual page 83

SAEx 07.2-UW SAEx 16.2-UW / SAREx 07.2-UW
ACExC 01.2 Non-Intrusive Profibus DP
Please state device type and our order number (see name plate) when ordering spare parts. Only original AUMA spare parts should be used.
Failure to use original spare parts voids the warranty and exempts AUMA from any liability. Representation of spare parts may slightly vary
from actual delivery.
Ref. no. Designation
002.0 Bearing flange
003.0 Solid shaft B1/B2/DD/B3D
005.0 Drive shaft
005.1 Motor coupling
006.0 Worm wheel
009.0 Manual gearing
017.0 Torque lever
018.0 Gear segment
019.0 Crown wheel
022.0 Drive pinion II for torque switching
023.0 Output drive wheel for limit switching
024.0 Drive wheel for limit switching
025.0 Locking plate
058.0 Cable for protective earth
070.0 Motor (only for V... motors incl. ref. no.
079.0)
079.0 Planetary gearing for motor drive (only for
V... motors)
500.0 Cover
501.0 Ex plug/socket connector with screw-type
terminals (KP/KPH)
501.1 Screw for control terminal
501.2 Washer for control terminal
501.3 Screw for power terminal
501.4 Washer for power terminal
502.0 Pin carrier without pins
504.0 Socket for motor
505.0 Pin for controls
SAREx 16.2-UW Control unit: electronic (MWG)
Type Ref. no. Designation
Sub-assembly 506.0 Pin for motor
Sub-assembly 507.0 Cover for electrical connection
Sub-assembly 511.0 Threaded plug
516.0 Output drive type D
516.1 Output drive shaft D
Sub-assembly 535.1 Snap ring
Sub-assembly 539.0 Screw plug
542.0 Handwheel with ball handle
549.0 Output drive type B3/E/B4
Sub-assembly 549.1 Output drive sleeve B3/E/B4
Sub-assembly 551.1 Parallel key
Sub-assembly 554.0 Socket carrier for motor plug/socket con-
nector with cable harness
Sub-assembly 557.0 Heater
Sub-assembly 559.0 Electronic control unit with magnetic limit
and torque transmitter (MWG)
Sub-assembly 583.0 Motor coupling on motor shaft
Sub-assembly 583.1 Pin for motor coupling
Sub-assembly 584.0 Retaining spring for motor coupling
Sub-assembly 627.0 MWG 05.03 cover
634.0 Shim washer (size 16.2 only)
635.0 Ball bearing
639.0 Retaining ring (size 16.2 only)
641.0 Shaft protection assy
Sub-assembly 642.0 Bellows assy
Sub-assembly S1 Seal kit, small
Sub-assembly S2 Seal kit, large
Spare parts
Type
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Set
Set
83