Fuse Replacement; Replace Fuses; Test/Replace Fuses - AUMA SAEx 07.2-UW Operation Instructions Manual

SAEx 07.2-UW
Corrective action
11.3.2.

Fuse replacement

11.3.2.1. Replace fuses F1/F2
11.3.2.2. Test/replace fuses F3/F4
Check fuses.
70
SAEx 16.2-UW / SAREx 07.2-UW
Information: Only valid for version with electrical connection of KES type, KT
type or KL type
Electric shock due to presence of hazardous voltage!
Death or serious injury.
Disconnect device from the mains before opening.
1. Remove electrical connection from actuator controls.
Figure 74:
2. Pull fuse holder out of pin carrier, open fuse cover and replace old fuses by
new ones.
Information: For version with electrical connection type KP/KPH, the fuses
(F1/F2) are also located on the PSU board.
1. Loosen screws [1] and remove cover [2] on the rear of the actuator controls.
Figure 75:
2. The power supply unit has measuring points (solder pins) allowing to perform
a resistance (continuity) measurement:
Table 31:
Checking
F1
F2
F3
F4
SAREx 16.2-UW Control unit: electronic (MWG)
ACExC 01.2 Non-Intrusive Profibus DP
Measuring points
MTP1 MTP2
MTP3 MTP4
MTP5 MTP6
MTP7 MTP8