Table of Contents
Advertisement
SAEx 07.2-UW
SAEx 16.2-UW / SAREx 07.2-UW
ACExC 01.2 Non-Intrusive Profibus DP
Lubrication
Notes relating to main-
tenance
12.4.
Disposal and recycling
In the factory, the gear housing is filled with grease.
Additional lubrication of the gear housing is not required during operation.
Perform maintenance with grease change after approximately 5 years.
We recommend replacing the seals when changing the grease.
After maintenance, perform leak tightness test at actuator and electrical connec-
tions.
The mobile PV 1691 leakage tester by AUMA can be used for leak tightness
test.
Perform visual inspection of actuator and mounted accessories. Ensure that
no outside damage, changes or leakage of grease and oil are visible.
Check actuator for unusual running or grinding noise or vibration which might
be an indication of bearing or gear damage.
Electrical connection cables must be placed properly and in perfect condition.
Thoroughly touch up any possible damage to painting to prevent corrosion.
Original paint in small quantities can be supplied by AUMA.
Cable entries, cable glands, plugs etc. have to be checked for correct tightness
and sealing. Consider torques according to manufacturer's details. If required,
replace the components. Only use components having an own EU type exam-
ination certificate .
Check whether Ex connections are fastened correctly.
Take care of possible discolouration of the terminals and wires. This would in-
dicate an increased temperature.
For Ex housings, pay special attention to a possible collection of water. This
may originate from "breathing" due to severe temperature variations (e. g.
change of night and day), from damaged seals etc. Remove any water immedi-
ately.
The process temperature range must be within the range of the specified ambi-
ent temperature.
Check the flame path gaps of flameproof enclosures for dirt and corrosion.
Since the dimensions of all flameproof joints are strictly defined and inspected,
no mechanical work (such as grinding) shall be performed on them. The joint
surfaces have to be cleaned chemically (e. g. with Esso-Varsol).
Consult manufacturer for indications regarding flameproof joints.
Repair interventions on flameproof joints is not permitted.
Prior to fitting, preserve joint surfaces with an acid-free corrosion protection
agent (e. g. Esso Rust-BAN 397).
Ensure that all housing covers are handled carefully and that the seals are
checked.
All cable and motor protection components have to be checked.
If defects impairing the safety are detected during maintenance, repair measures
have to be initiated without delay.
Any kind of surface coating for the joint surfaces is not permitted.
When replacing parts, sealing elements, etc. only original spare parts shall be
used.
Our devices have a long lifetime. However, they have to be replaced at one point in
time. The devices have a modular design and may, therefore, easily be separated
and sorted according to materials used, i.e.:
Electronic scrap
Various metals
Plastic materials
Greases and oils
The following generally applies:
SAREx 16.2-UW Control unit: electronic (MWG)
Servicing and maintenance
75
Advertisement
Table of Contents
