Formatting Removable Media - Software Version V2.X; Verifying Removable Media - GE Vivid 7 Service Manual

GE H
EALTHCARE
D FC091194, R
IRECTION EVISION
4-2-8

Formatting Removable Media - Software Version v2.x

NOTE: When formatting the MO disks, give them logical names and make sure to physically label the
disks.
- A labelling convention should be followed so that each MO disk gets a unique label.
- A maximum numbers of eleven (11) label characters are allowed in the label name.
- Use different labels on the MO disk's A side and B side.
1.) Label the MO Disks sequentially, i.e Image 1A (Side A), Image 1B (side B), Image 2A etc.
2.) Insert an MO disk, side A, into the empty MO drive.
3.) Press CONFIG (F2) and log on as adm, see
4.) Select Connectivity in the Image and Analysis menu.
5.) Select Tools in the Connectivity menu.
6.) In the Label window, type the same name as labelled on the MO disk side A.
7.) Select Format.
8.) A warning "Are you sure you want to format H: and remove all data from the media" appears, select
OK.
9.) Wait until the information dialogue window appears on screen.
10.)Select OK to continue.
11.)Verify the disk formatting status has been updated.
12.)Press ALT-E.
13.)Select the 5 1/4 MO Disk, to eject Disk.
14.)Insert the MO disk, side B and repeat step
4-2-9

Verifying Removable Media

1.) Insert the removable media you are going to verify into the correct drive
2.) Select the pre-configured removable media from the Config > Connectivity > Tools Media drop-
down menu.
3.) Press Verify. The unit starts to verify the DICOM directory on the selected media.
4 - 18
11
Figure 4-15 Prepare MO Disk - Image Storage
Section 4-2 - General Procedures
4-2-4 "Log On to the System as 'ADM'" on page
6 to 13.
V 7 S M
IVID ERVICE ANUAL
4-12.