Set The Scanner's Network Information - S/W V4.2/V5.2/V6.1/V7.X And Later - GE Vivid 7 Service Manual

GE H
EALTHCARE
D FC091194, R
IRECTION EVISION
3-9-6

Set the Scanner's Network Information - S/W v4.2/v5.2/v6.1/v7.x and later

(cont'd)
3.) Select (highlight) Internet Protocol (TCP/IP) and select Properties to display the Internet
Protocol (TCP/IP) Properties screen.
The Internet Protocol (TCP/IP) Properties screen is used to set the following parameters:
If using DHCP
Check the Obtain an IP address automatically check box.
If not using DHCP
1.) Uncheck the Obtain an IP address automatically check box, and enter the:
-
-
-
2.) Select OK to keep your changes or Cancel to close the Internet Protocol (TCP/IP) Properties
screen without keeping any changes.
3.) Select OK to close (and save) the Local Area Connection Properties dialog.
4.) Select the "x" in the upper right corner to close the Network Connections window.
11
Figure 3-40 Local Area Connection Properties
Figure 3-41 Internet Protocol (TCP/IP) Properties screen
IP Address for Vivid 7. (Default IP Address setting from factory: 10.0.0.3).
Subnet Mask for Vivid 7. (Default Subnet Mask setting from factory: 255.255.255.0).
IP address for Default Gateway. (Default Gateway setting from factory IP address: 0.0.0.0).
Chapter 3 - System Setup
V 7 S M
IVID ERVICE ANUAL
3 - 49