Configure The Administration Terminal - Nortel Meridian Mail Installation Quick Reference Manual

8-24

Configure the administration terminal

Introduction
Ignore the fields indicated by underscores in the figures illustrating setup
screens.
Note: Ensure the baud rate set for the terminal matches the baud rate of the
installed BootROM. If you need to verify the rate of the installed Enhanced
MMP40 or MMP40 card, see "Verifying the MMP40 card baud rate" in the
System Installation and Modification Guide (555–7001–215) for instructions.
Configuring an HP700/32 terminal
To configure an HP700/32 terminal, follow these steps.
Standard 1.0
Step Action
1 Press <
2 Change the values in each parameter field to match those
shown in " HP700/22 setup screens" on page 8-42.
Use the following keys to view and change setup values:
Up and down arrow keys Move from field to field.
Left and right arrow keys Scroll through possible values
<Enter>
<NextScreen>
<PrevScreen>
3 To save changes, press <F6> (SaveMenu) on each screen .
4 To exit setup mode, press <
Note: ROM Revision is a read–only field.
Modular Option EC Installation Quick Reference Guide
Installing peripheral devices and cabling
>.
SETUP
shown at the bottom of the screen.
Cause the action to take place in an
action field.
Move to next setup screen.
Move to previous setup screen.
SETUP
Configure the administration terminal
>.
November 1999