Nortel Meridian Mail Installation Quick Reference Manual page 149

Configuring the Meridian 1 for Meridian Mail
Configuring the AML link
Overlay 17—AML link configuration (X11 Release 17 or earlier)
Prompts Responses
REQ CHG
TYPE CFN
Note: The prompts in the shaded area below are applicable to NMS only.
ISDN YES
IFC SL1
RLS 16
IOTB YES
ADAN NEW TTY xx
CHG TTY xx
OUT TTY xx
ESDI YES
SYNC YES
DUPX LL
BPS 9600
CLOK EXT
IADR 3
LCTL YES
T1 10
T2 0
T3 40
N1 128
N2 8
K 7
Standard 1.0
Description
Change
Configuration data block
NMS only–To update the ISDN records
NMS only–Interface type
NMS only–Minimum Meridian 1 software release at the
far end is 16.
Make changes to logical units.
XX is the AML link number (0–15) which should be the
same as the ESDI device address (DNUM).
Port is on an ESDI card.
Synchronous mode required
Full duplex required
AML data rate
External clocking arrangement
Data link level HDLC protocol individual address
(identifies Meridian 1 at HDLC data link level)
Modify link control parameters
Retransmission time
Timer for no frame exchange
Timer for initial link setup
Maximum number of octets per HDLC information frame
Maximum number of retransmissions
Maximum number of outstanding frames
Modular Option EC Installation Quick Reference Guide
9-7
November 1999