Verify Disk And Tape Drive Jumpers And Terminators - Nortel Meridian Mail Installation Quick Reference Manual

Configuring the mass storage units

Verify disk and tape drive jumpers and terminators

Verify disk and tape drive jumpers and
terminators
Verifying disk drive jumpers and terminators
Refer to the disk drive illustrations on the following pages, for the drive
appropriate to your system.
Standard 1.0
Step Action
1 Set the SCSI ID on each primary drive (without a power pack)
to 0.
2 Set the SCSI ID on each secondary drive (with a power pack)
to 2.
3 Verify the other jumpers are set as shown in the appropriate
figure.
4 Remove all terminators from each disk.
5 Store drive(s) in their anti-static bags until they are required to
install into the Meridian Mail Module, as per the later chapters
of this guide.
Modular Option EC Installation Quick Reference Guide
4-3
November 1999