Nortel Meridian Mail Installation Quick Reference Manual page 105

Installing peripheral devices and cabling
Overview of installation
Installing and configuring modems for remote support
Use the following steps to install and configure the modems for remote support:
Ven–Tel S2 DIP switches
Modem setup strings
Standard 1.0
Step Action
1 If the modem is a UDS 224, put the front panel rotary switch in
the Data position.
2 If the modem is a Ven–Tel, set the S2 DIP switches as follows:
Switch Setting
S2–1 ON
S2–2 OFF
S2–3 OFF
S2–4 OFF
S2–5 OFF
S2–6 OFF
S2–7 ON
S2–8 ON
S2–9 ON
S2–10 OFF
3 Connect a straight RS–232 cable (NTND91AA/AB) from a
configured terminal to the modem.
4 Enter the modem setup string on the terminal, as follows:
Terminal Modem and
baud rate usage
9600 bps Ven–Tel 9600
Plus/9600 Plus
II
Ven–Tel 2400–
33/2400 Plus II
UDS 2440
UDS V3225
Modular Option EC Installation Quick Reference Guide
Result
Modem assumes data terminal ready (DTR) is
on
Not used
Not used
Not used
Not used
Not used
Speaker enabled
Modem will respond to commands
NVRAM command set enabled
Not used
Setup string
at&f *x1 &c1 3 0 %f2 0 s0=1 e0 q1 &w
at&f &d0 3 0 s0=1 s64=1 e0s14=12
&w
at&f3 &c1 s0=1 eos14=140 &w
at&f &c1 s0=1 e0 q1 &w
8-11
November 1999