Nortel Meridian Mail Installation Quick Reference Manual page 169

Configuring the Meridian 1 for Meridian Mail
Enabling the AML


25–05 CSL P Link is up
If other AML (Class 25) SEERs appear, see Maintenance Messages (SEERs)
Reference Manual (NTP 555–7001–510.)
To activate the AML (MSDL card, X11 Release 18 or later)
Use the link diagnostic program, Overlay 48
(NTP 553-3001-400, Release 18), to enable the AML port on the MSDL card.
To activate the AML (MSDL card, X11 Release 18 or later), follow these steps.
Status messages
The following messages appear on the Meridian 1 when the link is up:


ESDA002 (ISDN Applications Protocol Link <n> Link Layer is connected)


CSA003—Active ISDN Applications Protocol Link <n> is up
Meridian Mail issues the following SEER when the link is up:


25–05 CSL P Link is up
If other AML (CSL) SEERs appear, see Meridian Mail Maintenance Messages
(SEERS) Guide (NTP 555–7001–510).
Standard 1.0
Step Action
1 Enter LD 48 to load Overlay 48.
Note: The bold and italicized n ( n ) in the commands below
represents a variable. Substitute the appropriate information.
2 Enter ENL MSDL n (where n is the DNUM) to enable the card.
3 Enter SLFT AML n to test the MDSL pack for port n .
Enter DIS AML n LYR2 to disable AML port n .
4
Enter ENL AML n AUTO (where n is the AML number) to
5
initiate the Auto Setup sequence and establish the link.
6 Enter **** to exit from Overlay program 48.
Modular Option EC Installation Quick Reference Guide
9-27
November 1999