Nortel Meridian Mail Installation Quick Reference Manual page 110

8-16
Configuring a networking modem
For details, see the Networking Installation Guide (CPE) (NTP 555–7011–213).
Standard 1.0
Step Action
1 Set switch S2 as follows:
Switch Setting Result
S2–1 OFF
S2–2 OFF
S2–3 ON
S2–4 ON
S2–5 ON
S2–6 OFF
S2–7 ON
S2–8 ON
S2–9 OFF
S2–10 OFF
2 Temporarily connect the modem to a configured terminal and
enter the modem setup string on the terminal, as follows:
at&f &d3 &w
3 Turn off the modem for 10 seconds and then turn it back on.
4 Check the saved configuration by entering at. " Configuration
for the networking modem" on page 8-17 shows the
configuration information as it should appear on the terminal.
Repeat steps 2 and 3 if the information on the screen does not
match the information in " Configuration for the networking
modem".
Modular Option EC Installation Quick Reference Guide
Installing peripheral devices and cabling
Modem follows status.
DTR
Modem generates results in English for
commands.
Modem generates result codes for
commands.
Modem does not echo AT commands.
Modem does not automatically answer the
phone.
Modem Carrier Detect responds to carrier.
Modem speaker is enabled.
Modem will respond to commands.
NVRAM command set disabled.
Modem dialer feature is disabled.
Overview of installation
AT
AT
November 1999