Keyless Entry System (If Equipped); Keyless Entry System Operation Inspection; Keyless Entry System Circuit Inspection - Suzuki Wagon R RB310 Supplementary Service Manual

Table of Contents

Advertisement

8D-6 WINDOWS, MIRRORS, SECURITY AND LOCKS
1
8
7
6
5
18
17
16
15
14
13
V
2
3
1
4
3
2
1
12
11
10
9
Keyless Entry System

Keyless entry system operation inspection

1) Confirm that power door lock system is good condition.
2) Confirm that all doors are closed and unlocked.
3) Check the following operation:
a) When pushing "LOCK" button (1) on transmitter (2) once,
check all doors lock and hazard waning lights flash once.
b) When pushing "UNLOCK" button (3) on transmitter (2)
twice, check all doors unlock and hazard waning lights flash
twice and interior light turn on several seconds with the
interior light switch in the middle position.
c) For vehicle equipped dead lock system:
When pushing "LOCK" button (1) on transmitter (2) twice
within 2 seconds, check all doors lock and not pulled up all
door lock knobs by hand.
If check result is not satisfied, go to "Keyless Entry System Circuit
Inspection" in this section.

Keyless entry system circuit inspection

Check that the voltage between the following terminals and body
ground are specifications under each conditions.
If check result is not as specified, check applicable circuit.
If circuit is normal, recheck keyless entry system circuit as follows.
1) Substitute a known-good door lock controller.
2) Register key code referring to "Code Registration Procedure"
in this section.
3) Recheck keyless entry system circuit.
1. Door lock controller
(If Equipped)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wagon r rb413

Table of Contents