Selecting List Frequency Mode - Agilent Technologies NFA Series Quick Reference Manual

Making Basic Measurements
Setting the Measurement Frequencies
Step 3. Enter the frequency range by either entering the
frequencies, or the
Step 4. Press the
More 1 of 2
Step 5. Enter the number of measurement points using the numeric keys to
enter the number, press the

Selecting List Frequency Mode

You can create a frequency list in the following ways:
• Manually, by specifying each individual point
• From sweep points, by specifying the measurement frequency range
and setting the Noise Figure Analyzer to generate equally spaced
points within that range, using the
• Loading a list from the internal memory or diskette, where the data
has been previously stored.
• Loading a list using the GPIB Programmer, see the Programmer's
Guide if you want to use this method.
To Create a Frequency List Manually
Step 1. Press the
Frequency/Points
Step 2. Press the
Freq List
30
and the
Center Freq
, menu keys.
Points
key to terminate.
Enter
key and press the
menu key.
Start Freq
.
Freq Span
menu key.
Fill
menu key.
More 1 of 2
and
Stop Freq
Chapter 2