Monitoring The Operation Status - Mitsubishi Electric AE-200A Instruction Book

1-1-3. Monitoring the operation status

This section explains how to monitor the operation status of units.
[1] Air conditioning unit, LOSSNAY unit, Air To Water (PWFY) unit, and general equipment groups
Click [Monitor/Operation] in the menu, and then click [Show groups] to display the operation status of unit groups.
Controller
Click to narrow
down the groups
to display.
The operation mode currently in use is displayed in "Operation mode".
• Air conditioning unit group
Cool Dry
• LOSSNAY unit (ventilator) group
Bypass Heat Recovery
• Air To Water (PWFY) unit group
Heating Heating ECO
Note: In [Controller], it is possible to narrow down the unit groups for group display into "Centralized controller units," "Block units," and
"Energy management block units."
Note: The selection screen displays the centralized controllers to which unit groups set for general user management (in section 2-5-2
"User registration" in Chapter 2) are connected and the blocks and energy management blocks of unit groups set for general user
management.
Note: For how to configure centralized controller name setting, block and energy management block settings, and name settings, refer
to the Instruction Book (Initial Settings).
Note: The group name can be displayed using up to 10 double-byte, or 10 to 18 single-byte characters. The number of characters that
can be displayed differs depending on character type. Name setting is carried out through initial settings. Refer to the Instruction
Book (Initial Settings) for settings methods.
WT07996X02
Fan Heat
Auto
Hot Water Anti-freeze
153
Group icon
Auto Auto (Cool) Auto (Heat)
Cooling
Select all
Click to select all displayed
unit groups at once.
Deselect all
Click to cancel all selections
at once.
Room
temperature
Room humidity
Set temperature
Operation mode
Setback