Mitsubishi Electric AE-200A Instruction Book page 50

Item
Select an item to display its data in the bar graph.
Select a display range from [Block], [Group], [Address], or [Energy management block] to display its data.
The selectable items vary, depending on the display range. Only the items that can be displayed in the
graph appear. Refer to the table below for details.
■ Indoor unit
Address
Group
Block
Energy management
block
■ PI controller
Display items
for bar graph Address
*1 The electric energy (kWh) consumed by indoor units will appear in the graph. The values are apportioned
*2 A small amount of electric energy consumption (kWh) may appear in the graph even when no indoor units
*3 The indoor unit's cumulative operation time (minute) for the selected item will appear in the graph.
*4 Only "FAN operation time" is displayed for LOSSNAY units.
*5 Displays display item buttons for the name of the metering device connected to the PI controller. Names are
*6 If using a Pulse Input (PI), the display item buttons for the name of the metering device connected to the
*7 "Energy Management License Pack" is required. (AE-200E/AE-50E/EW-50E only)
*8 If "Energy Management License Pack" has not been registered, only [Day] is available for selection as a Date
WT07996X02
Display range
*7
*7
*7
*7
*5 *8 /Built-in Pulse Input (PI)
Display range
based on the setting for "Indoor unit operation apportioning mode". Refer to the Instruction Book (Initial
Settings) for the "Indoor unit operation apportioning mode" setting.
have been operated. This is because the standby electric energy is apportioned, which is normal.
• "FAN operation time" is the cumulative duration of time in which the indoor unit is ON.
• "Thermo-ON time (Total/Cool/Heat)" is the cumulative duration of time in which the refrigerant is flowing into
the indoor unit. (Cool: when the Cool mode is selected; Heat: when the Heat mode is selected; Total: when
either mode is selected)
those as set on the Measurement screen. If the name is not registered, then if the metering device units are
kWh, this will display "Electric energy 1"–"Electric energy 4", if the units are m
quantity 4", and if the units are MJ "Heat quantity 1"–"Heat quantity 4". If there are no metering device units "-",
then this will not be displayed. For how to register the names, refer to the Instruction Book (Initial Settings).
AE-200/AE-50/EW-50 CN7 will be displayed.
range. To select [Month] or [Year], "Energy Management License Pack" is required.
Description
Display items for bar graph
Display item
*3 *4
*1 *2
*6 *8
Display item
50
*3 *3
3 "Water quantity 1"–"Water
*3