Mitsubishi Electric AE-200A Instruction Book page 34

[5] Measurement Status
This section explains how to check the measurement data of the temperature sensors, humidity sensors, and
metering devices.
Click [Monitor/Operation] in the menu, and then click [Measurement Status] to display the Measurement Status
screen.
Note: An AI controller (PAC-YG63MCA), a commercially available temperature sensor, and a humidity sensor are required to
measure the temperature and humidity.
Note: A PI controller (PAC-YG60MCA) and a commercially available pulse-output metering device is required to measure the
electric, water, heat, and gas consumptions.
Note: A PI controller (PAC-YG60MCA) is not required when the built-in Pulse Input (PI) is used on the AE-200/AE-50/EW-50.
Measurement device icon
Measurement device name
Item
Controller
Measurement value
WT07996X02
Narrows down the measurement devices to display on a centralized controller basis.
The current measurement values will appear.
Note: The following icons are used to indicate the measuring devices. Icons will appear in orange
when the measurement value reaches the upper or lower alarm threshold value that has
been set in the initial settings. Refer to the Instruction Book (Initial Settings) for the settings
methods.
Temperature sensor
Humidity sensor
Metering device
*1 When there is a communication error, the measurement value of the temperature or
humidity sensor will be "--."
*2 When there is a communication error, the measurement value of the metering device will be
the measured value immediately before the error detection.
Description
Upper/lower alarm
Normal threshold value is
reached. (Orange)
34
Controller
Click to narrow down the
measurement device to
display.
Measurement value
Communication
error/sensor error
(Orange)
*1
*1
*2