Wheel Locks; Installing Wheel Locks; Adjusting The Brake Force - Physipro NeoX DYNAMIC Owner's Manual

ENGLISH

Wheel Locks

The installation of wheel locks must be done after the installation and adjustment
of the propulsion wheels is completed. Be aware that the size of the propulsion
wheels will affect the position of wheel lock brackets. If the propulsion wheel
installation has not been completed, consult section Installing propulsion wheels –
Threaded axle or Installing propulsion wheels – Quick-Release axle, depending on
your type of axle.
WARNING
If your wheelchair is equipped with pneumatic tires, always make sure
•
tire pressure is adequate before adjusting wheel locks.
Ensure that all bolts and nuts are securely fastened when
•
modifications have been made.
It is important that wheel locks are readjusted if modifications have
•
been made to the propulsion wheels or if propulsion wheels appear
worn.

Installing wheel locks

1. Position the wheel lock bracket on the side
frame rail.
2. Insert bolts A in the appropriate adjustment
holes and put nuts B on bolts A.
3. With two 13mm wrenches, firmly tighten
bolts A and nut B.

Adjusting the brake force

1. With a 5mm Allen key, loosen bolt C.
2. Move wheel lock in the wheel lock bracket's
slot D to obtain the required brake force.
- To increase brake force, move wheel lock
closer to the propulsion wheel.
- To reduce brake force, move wheel lock
further from propulsion wheel.
3. Firmly tighten bolt C.
NEOX TM
62
Dynamic wheelchair