Table of Contents
Advertisement
ENGLISH
Seat
Modifying seat depth
The seat depth of the Neox Dynamic
wheelchair can be changed by moving the
inner seat rails.
The following steps explain how to adjust seat
depth:
1. With a 5mm Allen key and a 10mm wrench,
unfasten bolts A.
2. With a 3mm Allen key and an 8mm wrench,
unfasten bolts B.
3. Remove both seat plates.
4.
With a 5mm Allen key and a 10mm wrench,
unfasten bolts C.
5. Slide inner seat rail D into outer seat rail E to
obtain
the
simultaneously adjust footrest depth.
6. Insert
screws
adjustment holes and tighten screws firmly.
7. With a 4mm Allen key and a 10mm wrench,
unfasten bolt assembly F at the rear section
of the seat.
8. With a flat punch, remove alignment
sleeves G.
9. Move the back post positioning plate
forward or backward to obtain the desired
depth.
10. Reinsert alignment sleeves G and bolt
assembly F and firmly tighten.
11. With a 3mm Allen key and an 8mm wrench,
loosen screws H and adjust the depth of the
seat plates.
12. Insert screws A and B in the appropriate
adjustment holes and firmly tighten screws
A, B and H.
For all seat depths ordered, the depth can be
increased or decreased by 1'' (25 mm).
desired
depth
C
in
the
appropriate
NEOX
TM
and
40
Dynamic wheelchair
Advertisement
Table of Contents
