T '' Type Armrest - Physipro NeoX DYNAMIC Owner's Manual

ENGLISH

'' T '' type armrest

The ''T'' type armrest is made with a foam
padding to improve comfort and can be
removed to facilitate transfers.
The ''T'' type armrest offers a height
adjustment range between 8'' and 15 ½''
(200 mm and 381 mm). Adjustable in
increments of ½''
Installing the '' T '' type armrest receiver
1. Position receiver A on the seat rail and
insert screws B through the receiver and
seat rail.
2. Place nut C on screw B and firmly
tighten using a 5mm Allen key and a
10mm wrench to hold nut C in place.
Installing the '' T '' type armrest
1. Press and hold down lever D.
2. Insert armrest into receiver A.
3. Release lever D to lock armrest in place.
Adjusting the '' T '' type armrest height
1. Press and hold lever E.
2. Raise or lower armrest.
3. Release lever E to lock armrest in place
once the desired height is obtained.
Note - Make sure the armrest height adjustment lock pins are fully engaged in the
adjustment holes and that set screw F is firmly tightened.
Adjusting the clothing guard height
1. With a 4mm wrench, loosen set screw G.
2. Position clothing guard I at the desired height.
3. Firmly tighten set screw G.
Removing the '' T '' type armrest
Press and hold lever D.
1.
2. Lift up and remove armrest.
NEOX TM
58
Dynamic wheelchair