Front Casters; Assembling And Installing The Front Caster Fork - Physipro NeoX DYNAMIC Owner's Manual

ENGLISH

Front Casters

The Neox Dynamic wheelchair can be equipped with polyurethane caster wheels and
are available in diameters of 5'' (127 mm), 6'' (152 mm), 7'' (178 mm) or 8'' (203 mm) with a
width of 1" (25 mm), 1¼'' (32 mm) or 1 ½'' (38 mm). Pneumatic caster wheels are also
available in diameters of 6''or 8'' (150 or 200 mm) with a width of 1¼'' (32 mm).

Assembling and installing the front caster fork

1. Install spacer A on bolt B.
2. Insert bolt B with spacer A through fork C.
3. Install spacers D and nut E onto bolt B.
4. Remove cap on caster stem housing.
5. Insert bolt B into caster stem housing.
6. Secure caster fork by tightening nut E with
a 19mm reversible ratchet, while holding
bolt B in place with a 19mm wrench.
7. Replace cap on caster stem housing.
Note -
Make sure the casters forks are
securely attached and that they swivel
easily. If not, loosen nut E slightly.
NEOX TM
38
Dynamic wheelchair