Reclining Gas Spring Backrest - Physipro NeoX DYNAMIC Owner's Manual

Owner's Manual

Reclining Gas Spring Backrest

The reclining gas spring backrest is pre-assembled in our factory. When replacing a
standard backrest with a reclining gas spring backrest, you must follow the steps in the
order indicated.
Note - The reclining gas spring mechanism cannot be installed with dynamic back
posts.
Installing the reclining gas spring backrest
1. Remove all the hardware of the standard
backrest (see section Removing the standard
backrest).
2. With a 5mm Allen key, remove screws A.
Slide the inner tubes into the outer tube,
until the desired width is obtained.
3. Insert sleeves B inside the seat rail, in the
appropriate seat depth adjustment holes.
4. Insert sleeve C through the mounting holes
of the lower back post and place in between
the positioning plates.
5. Place the positioning plates as illustrated.
6. Insert bolts D with washers through the
positioning plates and the seat rail, firmly
tighten bolts D with a 5mm Allen key.
47
ENGLISH
Revision 0
July 2022