Table of Contents
Advertisement
Owner's Manual
Propulsion Wheels
The Neox Dynamic wheelchair can be equipped with propulsion wheels of different
sizes, ranging from 12" to 24" (310 mm to 610 mm) and can be positioned at four
different heights.
Note – To ensure ease-of-installation and adjustment, we recommend that you
place your wheelchair on a flat surface, such as a table or workbench.
Installing the propulsion wheels -Threaded axle
1. Make sure the mounting block F
is properly positioned, if not,
please refer to section Modifying
the
position
mounting block.
2. Insert the axle bushing E in the
desired height-adjustment hole
of mounting block F.
3. With a
1⅛" wrench,
axle bushing E in place with lock
washers D and nut C.
4. Insert axle A through wheel hub
B and axle bushing E.
Tighten nut G with a ¾" socket
5.
wrench while holding axle A in
place with another ¾" socket
wrench.
Removing propulsion wheels -Threaded axle
1. Loosen nut C with a ¾" socket
wrench while holding axle A with a
¾" another socket wrench.
2. Remove nut C.
3. Slide axle A out of axle bushing B.
4. Remove axle A from wheel hub.
WARNING
After all adjustments or the reinstallation of the propulsion wheels, it is
essential that the stability of the wheelchair be verified. Adjustments to the
front caster wheels, the wheel locks, the anti-tips and the propulsion
wheel's mounting block may be necessary. Repositioning of the seat and
backrest may also be required. These adjustments must be performed by a
qualified technician.
of
the
axle
secure the
31
ENGLISH
Revision 0
July 2022
Advertisement
Table of Contents
