Disengaging Anti-Tips - Physipro NeoX DYNAMIC Owner's Manual

ENGLISH

Disengaging anti-tips

When being pushed by an attendant or
when clearing an obstacle, anti-tips
should be disengaged.
1. Press and hold button pin A.
2. Turn the anti-tips
towards the center of the frame.
3. Repeat the process for the
second anti-tip.
4. After an obstacle is cleared or if
the occupant is left unattended,
replace the anti-tips in their
initial position. Make sure anti-
tips are locked in place.
WARNING
Make sure anti-tips are locked in place and that the button pins and lock
•
pin protrude from the receiver mounting holes.
Anti-tips may be less efficient on wet surfaces, on clay or sandy soils, in
•
snow or gravel or uneven surfaces.
For maximum safety, it is recommended that anti-tips be installed no
•
higher than 2" above the ground. Adjusting anti-tips too low can make it
difficult to clear common obstacles, while adjusting anti-tips to high
increases the risk of tipping backwards.
Make sure both anti-tips are positioned at the same height.
•
Physipro Inc. recommends the installation of anti-tips on all wheelchairs.
•
Never tilt the wheelchair by pushing down on anti-tips.
•
inward,
66
NEOX TM Dynamic wheelchair