Standard Backrest - Physipro NeoX DYNAMIC Owner's Manual

ENGLISH

Standard Backrest

Modifying the backrest angle
The angle of the backrest can be adjusted to
accommodate the needs of the occupant.
1. With a 4mm Allen key and a 10mm wrench,
remove bolts B.
2. Once the bolts are removed, reposition the
back post at the desired angle.
3. Reinsert bolts B in the adjustment holes
corresponding to the desired angle and
tighten firmly.
Note - The interval between two consecutive adjustment holes is 5⁰. For a 120⁰
backrest angle, use the 115⁰ position in combination with the upper 120⁰ adjustment
hole. The 120⁰ backrest angle is achievable with standard back post only.
Removing the standard backrest
The Standard backrest can be removed and
replaced by a Dynamic or Reclining gas
spring backrest, if needed. The following
steps explain how to remove the standard
backrest positioning plates.
1. Remove armrests
wheels.
2. Remove cables and tilt activation
levers.
3. Remove backrest, tension bar and
stroller bar, if applicable.
a 10mm wrench, remove
4. With
screw A and lock washer and pull
out the upper back post.
5. With two 10mm wrenches, unfasten
bolts B and nuts C and remove
positioning plates.
Note - If positioning plates cannot be dislodged easily, remove the alignment
sleeves D, located in the seat rail, with a flat punch, this will facilitate the removal of
the positioning plates. Reinsert the alignment sleeves in the seat rail before
installing new positioning plates.
and propulsion
44
NEOX TM Dynamic wheelchair