Propulsion Wheels; Casters - Physipro SPIRAL Owner's Manual

ENGLISH

4.6 Propulsion wheels :

The Spiral tilt in space wheelchair can be equipped with 20" (50,8 cm) and 22" (55,9 cm) wheels
with a quick-release axle. This axle promotes the installation and removal of the wheel easily.
Adjusting the quick-release axle:
1. Install the quick-release axle
so that the balls (A) aren't
squeezed and completely
pass through the wheel
support (B).
2. If necessary, screw or
unscrew the nut (C) of the
quick release axle using a
3/4" wrench and a 7/16"
wrench.
Note – Adjust the quick-release
axle so that difference is at a
minimum when attempting to pull
the wheel out.

4.7 Casters :

The Spiral tilt in space wheelchair can accommodate 5" (12,7 cm) or 6" (15,2 cm) diameter
casters with a width of in between 1" (2,5 cm) and 1 - 1/2" (2,8 cm).
Installing the casters:
1. Determine the installation position of
the wheel (D) in the fork (E)
(See Annex B);
2. Insert the screw (A) into the hole
corresponding to the installation
position, taking care to install the wheel
(D) in between the 2 spacer rings (B);
3. Screw the nut (C) onto the screw (A)
using 1/2" wrenches;
4. Ensure that the wheel rotates;
Figure 28 : Adjusting the quick-release axle
Figure 29 : Installing the casters
28
28
Spiral
Révision 0
juillet 18