Intel SBCEFCSW Hardware Maintenance Manual page 49

Table 11. SNMP configuration settings (continued)
Entry
WriteCommunity
TrapCommunity
AuthFailureTrap
system
Prompts you, line-by-line, to change blade server configuration settings. Table 12 describes the
system configuration fields. For each parameter, enter a new value or press the Enter key to
accept the current value shown in brackets.
Table 12. System configuration settings
Entry
Eth0NetworkAddress
Eth0NetworkMask
Eth0GatewayIPAddress
Eth0NetworkDiscovery
AdminTimeout
Security Enabled
Remote Log Enabled
RemoteLogHost IP Address
Notes
The two components of security are user authentication and fabric security. The user must be
authenticated before gaining access to a switch. If an invalid account name/password combination is
entered, that user can not access the switch, and thus cannot gain access to the fabric. If security is
enabled (True) and a valid account name/password combination is entered, that user can access the
switch but can not execute any command that exceeds their authority (privileges) level. If security is
disabled (False) and a valid account name/password combination is entered, that user has access to
all switches in the fabric and can execute all commands (both user and admin), regardless of their
authority (privileges) level.
Intel® Server Switch Module SBCEFCSW
Description
Write Community Authentication. A write-only field; the value on the switch
and the SNMP management server must be the same.
Trap Community Authentication. A write-only field; the value on the switch and
the SNMP management server must be the same.
Specifies the IP address where a notification is sent in the event of an
authentication failure.
Description
Ethernet Internet protocol (IP) address
Ethernet subnet mask address for the Ethernet port.
Ethernet IP address gateway
Ethernet boot method (1 - Static).
NOTE
BootP, DHCP, and RARP do not apply
Specifies the amount of time in minutes the switch waits before terminating an
idle Admin session. Zero (0) disables the time out threshold. The default is 30;
the maximum is 1440.
Enables or disables the enforcement of account names and passwords.
Whether remote logging is enabled or disabled. If enabled, log information is
saved to a remote host that supports the systole protocol.
The IP address of the host that will receive the remote log information if
remote logging is enabled.
35