Table of Contents
Advertisement
Set Port command
Sets port state and speed for the specified port temporarily until the next switch reset or new
configuration activation. This command also clears port counters. For information about port
numbering and mapping, see Table 37 on page 127
NOTE
For external ports (0,15), all port parameters apply. For internal ports, only the port state
setting is configurable.
Authority
Admin
Syntax
set port [port_number]
• bypass [alpa] (for external ports only)
• clear
• enable [alpa] (for external ports only)
• speed [transmission_speed]
• state [state]
Keywords
[port_number]
Specifies the port. Ports are numbered beginning with 0. For information about port numbering
and mapping, see Table 37 on page 127
bypass [alpa]
Sends a Loop Port Bypass (LPB) to a specific Arbitrated Loop Physical Address (ALPA) or to
all ALPAs on the arbitrated loop. [alpa] can be a specific ALPA or the keyword ALL to choose
all ALPAs.
clear
Clears the counters on the specified port.
enable [alpa]
Sends a Loop Port Enable (LPE) to all ALPAs on the arbitrated loop. [alpa] can be a specific
ALPA or the keyword ALL to choose all ALPAs.
speed [transmission_speed]
Specifies the transmission speed for the specified port. Use one of the following port speed
values:
1Gbps
One gigabit per second.
2Gbps
Two gigabits per second.
Auto
The port speed is automatically detected.
Intel® Server Switch Module SBCEFCSW
33
Advertisement
Table of Contents
