Table of Contents
Advertisement
to accept the current value shown in brackets. Type q to cancel the configuration for one port, or
qq to cancel the configuration for all ports. Table 7 on page 25 describes the port parameters.
NOTE
For external ports (0,15), all port parameters apply. For internal ports, only the port state
setting is configurable. For information about port numbering and mapping, see Table 37
on page 127
ports [port number]
Initiates an editing session in which to change configuration parameters for all ports based on
the configuration for the port given by [port_number]. If you omit [port_number], port 0 is used.
For each parameter, enter a new value or press the Enter key to accept the current value shown in
brackets. Type q to cancel the configuration. Table 7 describes the port parameters. For external
ports (0,15), all parameters apply. For internal ports (1 through 14) only AdminState applies.
Table 7. Set Config port parameters
Parameter
AdminState
LinkSpeed
PortType
TLPortMode
ISLSecurity
SymbolicPortName
ALFairness
ARB_FF
InteropCredit
ExtCredit
FANEnable
LCFEnable
MFSEnable
MFS_TOV
Intel® Server Switch Module SBCEFCSW
Description
Port administrative state: online, offline, diagnostics,
or down.
1 Gbps or 2 Gbps
Type of port
Initiates the configuration of external ports attributes.
Indicates whether using initiator or target devices on
the loop. If you specify [port_number], the display will
present attributes for that port only; otherwise, all
attributes for all ports will be available for
configuration.
E_Port security. Determines which switches a port
will establish a link with.
•
Any - Will link with any switch.
•
Ours - Will link only to another Fibre Channel
switch module.
•
None - The port will not establish an ISL link.
Descriptive name
Default is switch that has priority
Use ARB_FF instead of idles on loop FCAL option
Number of buffer-to-buffer credits per port. 0 means
the default (12) is unchanged.
Extended credit port
Fabric Address Notification. If enabled, notifies
logged-in NL_Ports of the FL_Port address, port
name, and node name.
Link control frame preference, R_CTL = 0xC
Multi-frame sequence bundling
MFS limit for camp on
25
Advertisement
Table of Contents
