Table of Contents
Advertisement
Table 7. Set Config port parameters (continued)
Parameter
MSEnable
NoClose
I/O Stream Guard
IVIEnable
CheckAlps
switch
Initiates an editing session in which to change switch configuration settings. Each parameter is
displayed, one line at a time and prompts you for a value. For each parameter, type a new value
or press the Enter key to accept the current value shown in brackets. Type q to cancel the
configuration.
Table 8. Set Config switch parameters
Parameter
AdminState
Broadcast Enable
InbandEnabled
DefaultDomainID
DomainIDLock
SymbolicName
R_T_TOV
R_A_TOV
E_D_TOV
FS_TOV
DS_TOV
PrincipalPriority
ConfigDescription
26
Description
Management Server enable on this port
Do not close unless another device arbitrates
Enables or disables the suppression of RSCN
messages
Not applicable
Close before sending frames to new target
Description
Switch administrative state: online, offline, or diagnostics.
Enables (True) or disables (False) forwarding if broadcasting
frames.
Enables (True) or disables (False) the ability to manage the
switch over an ISL.
Default domain ID setting.
Prevents (True) or allows (False) dynamic reassignment of
the domain ID.
Descriptive name
Receiver Transmitter Timeout Value. Specifies the number
of milliseconds a port is to wait to receive a response from
another port. The default is 100.
Resource Allocation Timeout Value. The number of
milliseconds the switch waits to allow two ports to allocate
enough resources to establish a link. The default is 10000.
Error Detect Timeout Value. The number of milliseconds a
port is to wait for errors to clear. The default is 2000 msec.
Fabric Stability Timeout Value. The default is 5000 msec.
Distributed Services Timeout Value (Management Server,
Name Server). The default is 5000 msec.
The priority used in the FC-SW-2 principal switch selection
algorithm. 1 is high, 255 is low.
The name for the configuration. The default is undefined.
SBCEFCSW/SBFCM: HMM and Troubleshooting Guide
Advertisement
Table of Contents
