Table of Contents
Advertisement
FallingTrigger
SampleWindow
ISLMonitoringEnabled
RisingTrigger
FallingTrigger
SampleWindow
LoginMonitoringEnabled
RisingTrigger
FallingTrigger
SampleWindow
LogoutMonitoringEnabled
RisingTrigger
FallingTrigger
SampleWindow
LOSMonitoringEnabled
RisingTrigger
FallingTrigger
SampleWindow
The following is an example of the Set Config Zoning command.
FCSM: user1> admin start
FCSM (admin) : user1> config edit
FCSM (admin-config) : user1> set config zoning
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
AutoSave
Default
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
Set Log command
Specifies the type of entries to be entered in the event log. The log is a storage file contained on the
switch. The log can hold a maximum of 200 entries. When the log becomes full, the entries are
replaced, starting with the oldest entry, to produce a list of the last 200 events which occurred. Log
entries are created for ports, components, and event severity levels.
30
(decimal value, 0-1000)
(decimal value, 1-1000 sec)
(True / False)
(decimal value, 1-1000)
(decimal value, 0-1000)
(decimal value, 1-1000 sec)
(True / False)
(decimal value, 1-1000)
(decimal value, 0-1000)
(decimal value, 1-1000 sec)
(True / False)
(decimal value, 1-1000)
(decimal value, 0-1000)
(decimal value, 1-1000 sec)
(True / False)
(decimal value, 1-1000)
(decimal value, 0-1000)
(decimal value, 1-1000 sec)
(True / False)
[True]
(All / None)
[All ]
SBCEFCSW/SBFCM: HMM and Troubleshooting Guide
[0
]
[10
]
[True ]
[2
]
[0
]
[10
]
[True ]
[5
]
[1
]
[10
]
[True ]
[5
]
[1
]
[10
]
[True ]
[100
]
[5
]
[10
]
Advertisement
Table of Contents
