Expansion Card Error Messages - Intel SBCEFCSW Hardware Maintenance Manual

NOTE
See Chapter 6, "Parts listing," on page 157 to determine which components should be replaced by a
field service technician.
Message
Switch module x was removed
Switch module x was installed
Switch module x was powered on
Switch module x was powered on
Switch System running nonredundant
switch modules
Switch module%d IP configuration was
changed
ENET [X] DHCP HSTN=X, DN=X, IP @=
XXX.XXX.XXX.XXXGW @=
XXXX.XXX.XXX.XXX, SN=
XXX,XXX,XXX,XXX, DNS1@=
XXX.XXX.XXX.XXX
ENET [X] IP Cfg:HstName= XXXX, IP@=
XXX.XXX.XXX.XXX ,GW@=
XXX.XXX.XXX.XXX, NetMsk=
XXX.XXX.XXX.XXX Switch module x
was installed
LAN: Ethernet [x] interface is no longer
active
LAN: Ethernet [x] interface now longer
active

Expansion card error messages

NOTE
See Chapter 6, "Parts listing," on page 157 to determine which components should be replaced by a
field service technician.
Message
At the Expansion Card BIOS screen the
message "ERROR PC CONFIGURATION
ERROR" appears.
Symptom-to-FRU index
Action
Information only. Take action as required.
Information only. Take action as required.
Information only. Take action as required.
Information only. Take action as required.
Information only. Take action as required.
Information only. Take action as required.
Ethernet configuration information. Take action as required.
Ethernet configuration information. Take action as required.
Check cables to switch.
Information only. Take action as required.
Action
1. Replace the Expansion Card
2. Replace the Blade server
3.
4.
5.
151