Intel SBCEFCSW Hardware Maintenance Manual page 33

Quit command
Closes the Telnet session.
Authority
User
Syntax
quit, exit, or logout
Reset command
Resets the switch and port configuration parameters.
Authority
Admin
Syntax
reset
config [config_name]
factory
port [port_number]
snmp
switch (default)
system
zoning
Keywords
config [config_name]
Resets the configuration given by [config_name] to the factory default values for switch, port,
alarm threshold, and zoning configuration. This keyword clears all zoning definitions. If
[config_name] does not exist on the switch, a configuration with that name is created. If you
omit [config_name], the active configuration is reset. You must activate the configuration or
reset the switch for the changes to take effect. See Table 2 on page 20 through Table 4 on page
21
factory
Resets switch, alarm threshold, port, SNMP, zoning configuration, and blade server
configuration settings to the factory default values. The switch configuration is activated
automatically. See Table 2 on page 20 through Table 6 on page 22
port [port_number]
Reinitializes the port given by [port_number]. Ports are numbered beginning with 0. For more
information, see Table 37 on page 127
snmp
Resets the SNMP configuration settings to the factory default values. See Table 5 on page 22 for
SNMP configuration default values.
switch
Reinitializes the switch. This is the default. This command also closes the Telnet session.
Intel® Server Switch Module SBCEFCSW
19