Table of Contents
Advertisement
setup [option]
Changes SNMP and blade server configuration settings. See the "Set Setup command" on page
34.
switch [state]
Temporarily changes the administrative state for all ports on the switch to the state given by
[state]. The previous Set Config Switch settings are restored after a switch reset or a reactivation
of a switch configuration. [state] can be one of the following:
Online
Places all ports online
Offline
Places all ports offline.
Diagnostics
Prepares all ports for testing.
Set Config command
Sets port, switch, alarm threshold, and zoning configuration parameters.
Authority
Admin authority and a Config Edit session. See the "Config command" on page 10 for information
about starting a Config Edit session.
Syntax
set config
port [port_number]
ports [port_number]
switch
threshold
zoning
Keywords
port [port number]
Initiates an editing session in which to change configuration parameters for the port number
given by [port_number]. If you omit [port_number], the SBCE unit begins with port 0 and
proceeds in order through port 15. For each parameter, enter a new value or press the Enter key
to accept the current value shown in brackets. Type q to cancel the configuration for one port, or
qq to cancel the configuration for all ports. Table 7 on page 25 describes the port parameters.
NOTE
For external ports (0,15), all port parameters apply. For internal ports, only the port state
setting is configurable. For information about port numbering and mapping, see Table 37
on page 127
port [port number]
Initiates an editing session in which to change configuration parameters for the port number
given by [port_number]. If you omit [port_number], the SBCE unit begins with port 0 and
proceeds in order through port 15. For each parameter, enter a new value or press the Enter key
24
SBCEFCSW/SBFCM: HMM and Troubleshooting Guide
Advertisement
Table of Contents
