Table of Contents
Advertisement
4. If the blade server is operating, press the power-control button (behind the blade server control
panel door) to shut down the operating system and turn off the blade server. For the location of
the control panel door, see the illustration on page 149 Wait at least 30 seconds, until the drives
stop spinning, before proceeding to the next step.
5. Open the two release levers. The blade server moves out of the bay approximately 0.6 cm (0.25
inch).
6. Pull the blade server out of the blade bay. Spring-loaded doors further back in the bay move into
place to cover the bay temporarily.
7. Place either a filler blade or another blade server in the bay within 1 minute. The recessed
spring-loaded doors will move out of the way as you insert the blade or filler blade.
8. Lay the blade server down on a flat, nonconductive surface, with the cover side up.
9. Press the blade-cover release on each side of the blade server. Open the cover and lay it flat, or
lift it from the blade server.
CAUTION:
Hazardous energy is present when the blade is connected to the power source. Always
replace the blade cover before installing the blade.
Fibre Channel Expansion Card SBFCM
135
Advertisement
Table of Contents
