Appendix K Enable the Screen Saver of ViewPAC
Please set the following two items to enable the screen saver of the ViewPAC.
In the "Control Panel" > "Power" > "Schemes" , please select "Power Scheme" as "AC power" and then
set both "User Idle" and "System Idle" to the same value (or setting the "System Idle" value larger than
the "User Idle" value) and then remember to run "ViewPAC Utility" > "File" > "Save" and Reboot. The
ViewPAC will turn off the backlight when time is up if user doesn't touch it (screen and pushbuttons).
Then after in any time if user touches the screen or pushbutton, the ViewPAC will turn on the backlight
again.
To disable the screen saver, please set both "User Idle" and "System Idle" to "Never" and then
remember to run ViewPAC Utility > "File" > "Save and Reboot".
Ap-31
ISaGRAF WinCE ViewPAC User Manual , V.1.6 , 1/2017 by ICP DAS