Steps To Set Up A Web Hmi Demo; Step 1 - Set Up The Hardware; Step 2 - Setting The Web Options - ICP DAS USA ISaGRAF WinCE ViewPAC User Manual

3.2

Steps To Set Up A Web HMI Demo

3.2.1 Step 1 – Set up The Hardware
A. Please have one VP-25W7 and then plug one I-87055W board in its slot 0.
If you don't have the I-87055W (8 IN & 8 OUT board), please follow the same steps as below
however your Web HMI demo may be replaced to "vphmi_01" not "vphmi_05"
B. Prepare one Ethernet cable and then connect them to the ViewPAC. Keyboard is using the software
keyboard on the bottom-right of the ViewPAC screen)
C. Power up the ViewPAC.

3.2.2 Step 2 - Setting The Web Options

A. Please refer to the
B. Check on "Enable Web HMI" and then click on "Setting", Please check the "Enable Account Security"
and then click on "Edit" to set (username , password).
Note: If "Enable Account Security" is not checked, any user can easily get access to your ViewPAC
through the Internet Explorer.
3-2
Appendix A.3 to set a fixed IP address to the ViewPAC. (No DHCP)
ISaGRAF WinCE ViewPAC User Manual , V.1.6 , 1/2017 by ICP DAS
Then remember to click on "OK"