ICP DAS USA ISaGRAF WinCE ViewPAC User Manual page 122

I/O Connection Setting:
An empty LD is just fine
The ISaGRAF variables to be exchanged with InduSoft must be declared with a Modbus "Network
Address" as below.
Please save & compile the ISaGRAF example project & then download to the PAC.
If you are not familiar with ISaGRAF, please refer to
8-2
Please set No. as "Decimal"
In this example:
Please assign No. 1 to DI_1.
ISaGRAF WinCE ViewPAC User Manual , V.1.6 , 1/2017 by ICP DAS
No. 11 to DO_1
No. 21 to AO_1
No. 31 to Internal
section 4.1 to 4.3.